SquareTrade © AP6.0
Package of 25 New Metal Screed Chairs
Driver tool is not included in this listing.
Other listings do include the driver tool.
The screed chairs are used when pouring next to a building or wall or when your pad is wider than your screed you can set them in the center to screed off of. A Must for garage and basement floors. First set a stringline to finished grade about 12″ to 16″ away from the wall your pouring against. Next cut 1/2″ rebar to 18″ – 24″ in length. Drive those rebars about an inch away from the string every 3′-4′ apart. Using a hammer, drive the rebar into the ground until the top of the rebar is about the same level as the string line, then using the rebar driving tool finish driving them with a hammer till the pointer on the tool lines up with the string line. Screed Chairs sit on top of these rebars and provide a saddle for the temporary screed pipe. A 2″ OD pipe is used and is slid forward to the next Screed Chair as you screed the concrete, leaving the Screed Chairs free to remove and reuse. Use these against a building or in the center of a larger pour to provide an accurate and moveable screed system. 25 pieces per package. We have grade plates you can install if your driving the rebars in softer ground to help keep the rebars from sinking while screeding. Look at my other auctions for these.
The driver tool is available for purchase
it makes driving the chairs to grade very easy and quick. We have also a great formless footing system using the screed chairs along with rebar supports that make pouring footings very quick and easy using no forms, a great time saver. Visit my Ebay store.
This Package does not include the Driver Tool!
I do sell these individually and in packs of 100, 500, and 1000 on Ebay Email for a discount quote on larger quantities.
Contact us with any questions or comments.